New Testing Method Can Distinguish Marijuana From Hemp in Just Four Minutes, With 94% Accuracy, Study Finds

Researchers have developed a new method for distinguishing marijuana from hemp based on THC content in approximately four minutes, achieving 94% accuracy when tested on 36 cannabis samples, according to a study published October 27 in the journal Analytical Methods.

The study, conducted at Sam Houston State University in Texas, introduces a forensic testing technique that uses copper-based chemical compounds and mass spectrometry to identify THC while eliminating interference from cannabidiol (CBD). The technology could help laboratories process marijuana evidence more efficiently and reduce testing backlogs.

Researchers evaluated 13 different cannabinoids before applying the method to 36 authentic cannabis samples. The technique correctly classified 34 of the 36 samples, producing a 94% success rate. The two incorrect identifications were attributed to elevated concentrations of cannabinol (CBN), a cannabinoid that can form as THC degrades.

The testing process uses a technique known as paper spray ionization mass spectrometry, which allows chemical compounds to be analyzed without the lengthy separation procedures commonly required by conventional testing methods. By introducing a copper-phosphine compound, researchers were able to generate a distinctive chemical signal associated with delta-9 THC.

Importantly, CBD did not produce the same detectable signal, allowing the method to distinguish THC without interference from a cannabinoid commonly present in hemp. This addresses one of the challenges forensic laboratories face when analyzing cannabis products containing multiple chemically similar cannabinoids.

The research comes as laboratories continue adapting to federal hemp regulations established by the 2018 Farm Bill, which generally distinguishes hemp from marijuana using a threshold of 0.3% delta-9 THC by dry weight. Determining whether cannabis material exceeds that limit can require specialized testing equipment and time-consuming laboratory procedures.

For this study, researchers established a semi-quantitative testing method using a more conservative 1% THC decision threshold. Although this differs from the federal 0.3% hemp limit, the approach demonstrates how faster testing could help laboratories identify higher-THC cannabis samples without relying on more extensive conventional analysis.

The approximately four-minute testing time refers to the analytical method, with additional preparation required before samples can be examined. Researchers also evaluated the method’s precision, selectivity, detection limits and potential for contamination between samples.

The research was supported by the U.S. Department of Justice’s National Institute of Justice, which funds scientific advancements intended to improve forensic investigations and criminal justice procedures.

The findings suggest that copper-assisted mass spectrometry could provide forensic laboratories with a faster alternative for identifying marijuana, although the misidentifications involving CBN and the higher testing threshold demonstrate areas requiring further refinement before broader implementation.

The method could substantially reduce testing times compared with existing laboratory procedures. A testing method developed by the National Institute of Standards and Technology requires less than 30 minutes per sample, even after improvements reduced processing times from more than 70 minutes. However, the new technique’s 94% identification rate does not establish greater accuracy than conventional methods, which can also measure THC at concentrations below the new method’s 1% testing threshold.